Well mPBX-36 Spécifications télécharger pdf (Page 16)

WELL mPBX-U110R Administrator's Guide

Page16

Step2: Enter the IP Address.

Step3: Enter the Subnet Mask.

Step4: Enter the Gateway Address.

Step5: Enter the Primary DNS and Secondary DNS.

Step6: Click the Save button to save the settings.

Step7: Reboot the device.

Step8: Check the WAN’s Status (Status Network status).

·PPPoE

If your DSL provider says that you are connecting through PPPoE or if you

normally enter a user name and password to access the Internet, perform these

steps:

Step1: Select PPPoE as the WAN Connection Type.

Step2: Enter the User Name.

Step3: Enter the Password.

Step4: Click the Save button to save the settings.

Step5: Reboot the device.

Step6: Check the WAN’s Status (Status Network status)

5.1.3 DHCP Server

Dynamic Host Configuration Protocol (DHCP) is a network protocol that enables

a server to automatically assign an IP address to a computer from a defined

range of numbers (i.e., a scope) configured for a given network. You can set a

local network NTP server for mPBX here too

Note: WELL mPBX-U110R can be working as a DHCP server, but cannot be

regarded as an router. When using ‘Phone Provisioning’ for Grandstream IP

phone, Enter the IP address of the server directly, e.g.:192.168.5.150; for

other phones using the default configuration.

Figure 5-3

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 144 145

Pas de commentaire

Well mPBX-36 Spécifications Page 16